Catálogo de Partes

Safety Monitoring Module

Motor circuit breaker, TeSys Deca, 3P, 1 to 1.6A, thermal magnetic, screw clamp terminals, button control

StrideLinx Basic industrial VPN router, wired Internet connectivity, (5) Ethernet Gigabit (RJ45) port(s), Android/iOS with mobile VPN, 12-24 VDC required.

Industrial unmanaged Ethernet switch, 5 ports, (5) RJ45 Gigabit port(s), -40 to +75 deg C, metal housing, IP30, 35mm DIN rail mount, hazardous location rated.

Stride_SE-SW5M_Layer 2 Managed Ethernet Switch

STRIDE industrial unmanaged Ethernet switch, 5 ports, (5) Ethernet 10/100Base-T (RJ45) port(s), -10 to +60 deg C, metal housing, IP30, 35mm DIN rail mount.

Industrial unmanaged Ethernet switch, 5 ports, (5) RJ45 Gigabit port(s), -40 to +75 deg C, metal housing, IP30, 35mm DIN rail mount, hazardous location rated.

STRIDE industrial managed Ethernet switch, 8 ports, (8) Ethernet 10/100Base-T (RJ45) port(s),
EtherNet/IP and Modbus TCP, -40 to +75 deg C, metal housing, IP40, 35mm DIN rail mount.

STRIDE industrial unmanaged Ethernet switch, 8 ports, (8) Ethernet 10/100Base-T (RJ45) port(s), -40 to +75 deg C, metal housing, IP30, 35mm DIN rail mount.

Industrial unmanaged Ethernet switch, 5 ports, (4) RJ45 10/100 POE+ and (1) RJ45 10/100 port(s), 48 VDC nominal input, -40 to +75 deg C, metal housing, IP30, 35mm DIN rail mount, hazardous location rated.

Industrial unmanaged Ethernet switch, 5 ports, (4) RJ45 Gigabit POE+ and (1) RJ45 Gigabit port(s), 48 VDC nominal input, -40 to +75 deg C, metal housing, IP30, 35mm DIN rail mount, hazardous location rated.

PoE Industrial-Switch; 2-Port 1000BASE-T; black

STRIDE industrial unmanaged Ethernet switch, 5 ports, (5) Ethernet 10/100Base-T (RJ45) port(s), -10 to +65 deg C, metal housing, IP30, 35mm DIN rail or panel mount.

Ex safety sensor Ex HS Si 4 2Ö - 10m

The Automated Logic® SE controllers are an integral component of the WebCTRL building automation system.
The SE controllers are fully programmable, native BACnet advanced application controllers that provide a rugged solution for single-equipment applications.
Designed to operate in a wide range of environmental conditions, SE controllers can be used inside rooftop units, mechanical rooms, equipment closets, or almost any other weather-tight location.

SATELLITE SYNCHRONIZED CLOCK

AUTOMATION CONTROLLER

Temperature transmitter

Temperature transmitter

Temperature transmitter

Analog thermocouple amplifier board based on the AD849x from Analog Devices (successor of the AD597). This quad-channel thermocouple board converts the very low voltage signal from a thermocouple to a highly-linear, 0.005V/°C output with either 0V or 1.245V offset (both configurations stocked) while removing unwanted noise from the signal.

Many supply and output configurations are available with this board, though the PCB was designed with Arduino in mind. Specifically, the output header will plug directly into a standard Arduino Uno or Mega, with a pin-for-pin match for power supply, ground and analog outputs. With a 5V Arduino, temperatures from 0°C to 1,000°C are possible with the 0V offset board and -249°C to 750°C with the 1.245V offset board. If using a 3.3V microcontroller (Due, etc), the board must be supplied with no more than 3.3V to avoid damaging the microcontroller.

Temperature measurement range is dependent on the supply voltage. It is possible to supply the board with higher voltages to allow temperature measurement over the entire operating range of the K-Type and J-Type thermocouples, allowing use with more capable data acquisition equipment.

PoE+ switch,120W, 5 ports, (4) PoE+ Gigabit (RJ45) and (1) Gigabit (RJ45) port, 12-55 VDC

UPS RIELLO SENTINEL PRO SEP1500 1500VA/1350W

Series 2 KIP D261010 24Vdc

24V DC IN 0-10VDC OUT