Details: <p><strong>Testing:</strong></p><p style="margin-left: 40px;">- Insert any symbol on a sheet, and make sure a &#39;Control&#39; connection is connected to one of the symbol&#39;s connection points.</p><p style="margin-left: 40px;">- Reach the properties of the symbol&#39;s connection point, and make sure the &#39;Numbering by connected component numbering format&#39; is assigned to that connection point&#39;s &#39;Connected wire numbering format&#39; property. (and make sure the &#39;Follow through&#39; check box of teh numbering format is checked.)</p><p style="margin-left: 40px;">- On the inserted &#39;Control&#39; connection, insert a pilot light symbol.&nbsp; (Or any symbol not having connection point groups defined, but having opposed conection points.)</p><p style="margin-left: 40px;">- Right click the pilot light symbol and choose &#39;Explore block&#39;</p><p style="margin-left: 40px;">- Make sure the &#39;Wire numbering follow through&#39; check box is checked.</p><p style="margin-left: 40px;">- Run wire numbering.</p><p style="margin-left: 40px;">- If the number of the connection on the other side of teh pilot light is numbered based on the first inserted symbol, we&#39;re good!&nbsp; If teh numbering corresponds to the standard &#39;Control&#39; connection numbering format, it&#39;s bad..</p>